When your amigurumi won't sit up: five honest fixes

A character that tips forward every time you put it down is almost always a construction issue, not a bad pattern. Work through these five checks in order; stop when it sits.

1. Add filling at the base, not everywhere

Press a little extra fibre fill into the bottom third of the body, then reshape. Adding filling evenly often makes the piece rounder but no more stable.

2. Move the legs forward

If the legs are sewn on, unpick one at a time and place them about half a stitch further forward and slightly wider. Two small changes in position often do more than a complete re-stuff.

3. Check the bottom is actually flat

A rounded bottom rocks. If your increases put stitches around the whole circumference, try a pattern with a flatter base or add a few extra rounds before you start decreasing.

4. Compare your gauge with the pattern

A larger hook or a stretchier yarn makes a taller, softer piece with a small base. If your finished size is much bigger than the pattern states, the proportions will be off even though the stitch count is right.

5. Accept a leaning character

Some handmade pieces simply sit with a bit of character. If the face still reads well and nothing is falling off, that may be the finished look — not a fault to fix.

Our amigurumi patterns include a placement diagram and a troubleshooting page for exactly this reason. If you're stuck on one of ours, send us a photo and we'll help.

One useful pattern note, now and then.

New releases, corrections and a free pattern. No daily noise.

Join the letter by email